Skip to content
FairbankLock Experts · RunnymedeOpen 24/7(289) 804-2598Request a visit
FairbankFairbankLOCK EXPERTS
Person seated at a wooden table examining a brass mortise lock body, with a tool roll, small lock parts and a mug. — Runnymede

Locksmith in Runnymede, OntarioBroken key?Leave the pieces to us.

Cold mornings in Runnymede are hard on tired brass, and a key that has been bending for years finally lets go inside the lock. We remove the snapped piece without harming the cylinder, look at why it failed, and cut a fresh key from the code or the remaining half before we leave.

Toronto, Ontario

Runnymede information

Town
Runnymede, Toronto, Ontario
In business
21 years
Hours
Open 24/7, same fees any hour
Visits
On-site assessment preferred

2021 census · what it means at the door

  • 58%Older homes

    About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.

    Older homes tend to have had many hands on their doors: owners, tenants, tradespeople, family. A locksmith visiting such a house pays attention to who holds keys now, and rekeying or a keyed-alike set often matters more than any new hardware.

  • 23%

    Single-detached houses make up about 23% of homes in Toronto (2021 Census).

    Shared entrances mean fobs, intercoms and buzzers alongside conventional locks. A locksmith can service the mechanical side of those doors and advise on how the fob system and the cylinder work together when management asks.

Source: Statistics Canada, Census Profile

Locksmith services

From lockouts to master keys

To orient yourself, the services available in Runnymede fall into five groups: urgent openings, residential lock work, higher-security upgrades, commercial doors and key control, and safes. A sixth, vehicle keys, is there for households that want one company for every key on the ring.

Lockouts

Lockout Services

If the key will not turn, the key is in two pieces, or the door was kicked and no longer closes, this is the section. Each page describes how we open, extract or secure, and what we check before calling the job finished.

Runnymede

Calls like these

Technician in a cap working a screwdriver at a steel lock plate on a navy door, with an open tool bag behind. — Runnymede

Home Lockout Service

After a week of humid weather the back door has swollen in its frame. The key turns, you can feel the bolt trying to move, but it is jammed hard against the strike plate and the door refuses to open.

Home Lockout Service
Ceramic dish holding keys on a wooden table beside a leafy vase, with a black door, deadbolt and knob behind. — Runnymede

Runnymede

Have a locksmith look at your Runnymede shop

You will not be talked into more than the door needs. In Runnymede we grade what is fitted, name the one change that would matter most, and stop there unless you ask for more. A household that wants the full upgrade can have it; a household that wants the sticking bolt fixed gets exactly that, done properly.

— Fairbank Lock Experts

  • A straight assessmentIf the lock is fine and the door just needs adjusting, we say so. If it has reached the end of its life, we say that too, and show you why.
  • Options laid out side by sideRepair, rekey, replace or upgrade, with what each involves and what it changes. You pick; we do not steer you toward the biggest job.
  • Finished, not nearly finishedEvery key tested in every lock, every screw tight, every strike aligned, and the packaging in our van rather than your bin.

Hours

  • HoursOpen 24/7
  • Nights and weekendsSame fees
  • In business21 years
  • VisitsOn-site assessment

Open 24/7

How a visit goes

Businesses are locked out by people as often as by hardware. A keyholder is away, a former employee still has a key, a master key has gone missing, or the only spare lives in a drawer behind the locked door.

Drawing: a house seen from the street. The van pulls up, the garage door is opened for the work, then it closes level and the porch light comes on.
  1. 1 of 3

    Verifying the caller

    We ask for something that ties you to the premises: a lease, business card, or a call to the owner. Opening a shop for the wrong person is not a risk we take.

  2. 2 of 3

    Getting the door open

    Storefront and office locks vary, so we choose the approach that leaves the hardware intact wherever possible. If the lock itself has failed, we tell you before opening it.

  3. 3 of 3

    Getting you back to trading

    Once inside we check the lock, cut keys if needed and note anything that should be addressed later so your day can carry on.

Your questions, our answers

(289) 804-2598

How long does a home lockout usually take once the locksmith arrives?

The opening itself is often the shortest part of the visit; verifying identification, examining the lock and testing the door afterwards take a share of the time too. A standard knob or deadbolt on a well-fitting door is generally a matter of minutes, while a high-security cylinder, a frozen lock or a swollen door takes longer. If a cylinder has to be drilled and replaced, or locks are rekeyed while the locksmith is there, allow extra time for that work.

What lubricant should I use on the lock afterwards?

Whatever the lock's own maker specifies, since cylinders differ: many call for a dry graphite or PTFE spray blown into the keyway and worked in with the key, once or twice a year, while others prohibit graphite and specify their own product instead. General-purpose oils, grease and sprays feel smooth at first but on most cylinders collect dust and clog the pins, which leads back to the sticking that breaks keys. A little goes a long way; too much of any lubricant can also hold moisture.

Should I rekey when I move into a new home?

Lock manufacturers list moving as one of the main reasons to rekey, and it is easy to see why: previous owners, their relatives, a cleaner, a dog walker and a contractor may all hold copies you know nothing about. Rekeying every exterior cylinder in one visit resets the count to the keys in your hand, and it is a convenient moment to put every door on a single key as well.

How long does servicing a mortise lock take?

A single entry lock that needs cleaning, springs and a strike adjustment is generally done in one visit of an hour or two. Filing a bit key adds bench time, and a set of interior latches is longer simply because there are more of them. A case that needs a part fabricated, or a replacement case that has to be ordered to size, may mean a second visit; the locksmith says so at the assessment.

Can you install a safe I already bought somewhere else?

Yes. Bringing your own unit is common, and the installation itself does not depend on where the safe came from. The locksmith still needs to check its weight, its footprint, and its anchor points against the floor or wall it will sit on, and looks over the lock before calling the job complete, since a new-to-you safe occasionally arrives with a stiff mechanism or a combination still set from the factory.

On-site assessment preferred

Request a visit

Describe the problem; we'll take it from there. Talk to a locksmith about it.

Fairbank Lock Experts

Locksmith · Runnymede

Open 24/7

(289) 804-2598

21 years in business

Open 24/7 · call(289) 804-2598Request a visit